UV Transfer Instructions & Care Guide

1. Application Instructions

UV DTF transfers are peel-and-stick decals designed for hard surfaces. No heat press is required.

Step-by-Step Application

1. Clean the surface Ensure the surface is clean, dry, and free of dust or oils. Use isopropyl alcohol for best adhesion.
2. Rub the back of the transfer Rub the back of the transfer with a squeegee.
3. Peel the backing Carefully peel the backing sheet away from the transfer. For larger transfers, it is best to do this slowly while applying. Do not touch any area of the transfer.
4. Position the transfer Place the design onto the surface exactly where you want it.

   ⚠️ Once applied, it cannot be repositioned.

5. Apply pressure Use your fingers or a squeegee to press firmly across the design. Work from the centre outward to remove air bubbles.
6. Remove the top film Slowly peel away the carrier film, leaving the design on the surface.
7. Apply pressure Use your fingers or a squeegee to press firmly across the design.

2. Suitable Surfaces

UV DTF transfers work best on smooth, hard surfaces.

Recommended Surfaces

• Glass
• Metal
• Plastic
• Acrylic
• Powder-coated drinkware
• Ceramic

Surfaces to Avoid

• Fabric
• Silicone
• Rubber
• Textured surfaces
• Soft plastics

3. Storage Instructions

UV DTF transfers should be stored correctly to maintain adhesion.

Best Storage Conditions

• Store flat
• Keep in a cool, dry environment
• Avoid direct sunlight
• Avoid excess heat or humidity

Shelf Life

📅 For best adhesion, use transfers within 6 months of purchase.

4. Aftercare Instructions